Saw Control Systems
About Saw Control Systems
Saw Control Systems is based in Kooskia, Idaho, and shows up under the mills category. It isn't a service that buys standing timber or walks a landowner's woods to mark trees. Instead, it builds and installs the electronic controls that sawmills use to run their saws. Its own words describe it as having produced "the first electronic joystick sawing control for hydraulic shotgun carriages." The work covers real-time bandsaw monitoring, feedback to the people running the mill floor, and diagnostic data to help troubleshoot problems as they come up. A sensor is mounted near the saw guides to measure deviation and vibration while the blade is cutting, and that signal feeds back to a control unit, often set up in the mill's filing room, so operators can adjust feed speed and catch wear or alignment problems before they cause downtime. The company has been at this a long time, putting it plainly as "WATCHING SAWS SINCE 1982." It serves Idaho. No species or acreage comes into play here, since this isn't about buying or cutting trees off a particular piece of ground, it's about the equipment that runs inside a sawmill itself. This fits a sawmill operator looking to upgrade saw control and monitoring, not a landowner trying to sell timber off a few acres. From sawcontrol.com, read 4 October 2026.
Everything they're registered for
Counties covered
Saw Control Systems
Tell us what you're trying to do and we'll make the introduction. Free, no obligation.